Tear circle SFSP998 series hammer mill 

Features：

1. The grinding chamber is of tear circle shape, effectively eliminating the circular flow in the grinding process and getting higher capacity;

2. The Bottom of grinding chamber is fitted with U-shape double grinding structure, further improving the capacity with evener particle size;

3. Rotor passes accurate dynamic balancing test, resulting in low equipment noise and smooth running.

4.Both coarse and fine grinding is realized through adjusting the gap between beater and screen;

5. New type S shape coupling directly connecting driving results in big offset travel and effectively avoid the heating of bearing;

6. Beater blade edge is vacuum-welded by special alloy steel, resulting in long service life;

7. The imported products are used for key parts, resulting in long service life and low maintenance cost;

8. The moving full-wide operation door facilitates maintenance and replacing of beater;

9. It is widely used in various feed mills, oil plants, alcohol plants, citric acid plants, etc.

Main Technical Parameters：

Re: The above indices are those when meeting the following conditions: raw material: corn, moisture content not higher than 14%, density not lower than 0.72t/m³, screen: hole diameter ï¿ 3mm, hole-opening rate not less than 33%.